 | . |  |
| ATB network | |
|
|
| Do-it-yourself : The multi-chambres filter made of wood 3 |
Then the delicate transaction, the cuts two boards of bias, to draw to the scale and to measure the angles, he remains to cut them to the circular saw.
Then to cut the two baffles in V of the upflow (l 48 X H 43 cm) that goes until in the bottom and to fix the lath of 10 cm bottom with passes them then partitions on these two baffles to fix at an angle in the Tec7 the two laths and to screw them also in the baffles.
After this transaction, to fix the two lateral partitions (L 63 X H 60 cm) then, the two frontal partitions (122 X 60 cm) that come to come in between, they are screwed in the partitions of the upflow and to the lateral partitions.
The 3 partitions of the uplfow are cut then to come to deposit themselves on the top edge of the V, they are fixed in the Tec7 and are screwed at the frontal partitions.
Finally, two reinforcements are placed at the middle under the two big chambers.
It is not necessary if one uses the second option for the bottom.
Well on him will be necessary to make a large seal of Tec7 on all sides of the partitions, it is for this reason that the distance between the baffles of the upflow makes 6 cm, distance leaving the possibility to pass the arm for the Tec7 seal.
For the entry of water, I used a plug to screw 32 mm with an elbow external side, the one is pasted to the Tec7 of the two sides of the partition here.
|
 |
|
|
| Visits | |
| Partenairs | |
|
.jp
|
|
.be
|
|
.be
|
|
.be
|
|
|
.be
|
|
|
.be
|
|
|
.nl
|
|
.nl
|
|
.nl
|
|
|
.uk
|
|
|
.uk
|
|
|
.de
|
|
|
.de
|
|
|
.de
|
|
|
.eu
|
|
|
.es
|
|
|
.se
|
|
|
.lu
|
|
|
.it
|
|
|
.us
|
|
|
.us
|
|
|
.us
|
|
|
.my
|
|
|
